Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 4)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Installing and Connecting a WLA

Installation Requirements and Recommendations

For best results, follow these requirements and recommendations before installing a WLA.

RingMaster Network Plan and Work Orders

If you are using RingMaster to plan your Juniper Networks Mobility System installation, you might want to

create and verify a network plan for the entire Juniper Networks installation and generate an AP work order

before installation. A network plan and the AP work orders generated from it provide the following information

about AP installation and configuration:

 Number of APs required for adequate WLAN capacity in each coverage area

 Detailed installation location for each AP

 Settings for all APs in the WLAN

Wireless Lan Controller (WLC) Appliance Recommendation

Juniper Networks recommends that you install and configure the WLC before installing an AP. If the WLC is

already installed and configured for the APs, you can immediately verify the cable connection(s) when you plug

the cable(s) into the AP.

Wall Installation Recommendations

If you plan to install the AP on a partial wall or other vertical surface, orient the top of the AP (the side with the

LEDs) toward the intended coverage area. The radio antennas transmit through the top of the AP but not

through the bottom, where the bracket is located.

This recommendation does not apply if you are installing the WLA522E. Orient the antennas as shown in

WLA522E Installation Antenna Orientation on page 32.

AP Radio Safety Advisories

When you enable the AP radio(s) as part of WLC configuration, the radios can receive and transmit radio

frequency energy as soon as you connect the AP to the WLC, either directly or through the network.

Informational Note: Before installing an AP, you might need to generate a network plan and an AP

work order with RingMaster. (See RingMaster Network Plan and Work Orders below.)

Informational Note: System Administrators and equipment installers of the WLAN System are

responsible for the proper setup and operation in accordance to all rules and regulations of the country in

which the equipment operates.

Warning: An Indoor AP is designed to receive power only from an 802.3af-compliant source, a Juniper

WLC, or a Juniper Networks-approved power injector. Connecting an AP to a Power over Ethernet

(PoE) device not approved by Juniper Networks can damage the equipment.

1 2 3 4 5 6 7 8 9 ... 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 4