Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 23)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Figure 19: Step 7—Locking the Bracket

9. To ensure that the AP is fully locked onto the bracket, gently pull down on the AP and attempt to rotate it

from side to side.

10. If the AP comes off the bracket, relock the device onto the bracket.

11. If the AP requires an external antenna, install and connect the antenna.

Solid Wall or Ceiling Installation

1. Prepare holes in the wall or ceiling for the universal mounting bracket, using the following steps:

a. Place the paper mounting template over the location to install the AP.

b. Mark the screw hole location(s).

c. If you plan to route the Cat 5 cable externally along the wall or ceiling, mark the locations of both the

center screw hole and the screw hole by the port connector opening.

d. If you plan to route the Cat 5 cable through a hole in the wall or ceiling, mark the location of the center

screw hole only. You cannot use the screw hole by the port connector opening if you cut a hole for the

opening.

e. Remove the template.

2. Install the drywall anchor(s):

a. Hammer a drywall anchor into each hole, up to the beginning of the threads on the anchor.

b. Screw each anchor the rest of the way into the hole using a #2 Phillips-head screwdriver.

Lock

Informational Note: The solid surface mounting option requires Cat 5 cable that does not have strain

relief, unless you plan to route the cable through a hole in the wall or ceiling. The other options can use

Cat 5 cable with or without strain relief.

Informational Note: Do not mark the four holes on the edges of the bracket. The AP fits into these

holes. They are not screw holes.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 23