Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 25)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

6. Insert the #6 sheet metal screws into the screw holes, and tighten them to secure the universal mounting

bracket to the wall or ceiling. If you routed the Cat 5 cable through a hole in the wall or ceiling, insert the

screw into the center screw hole only.

Figure 22: Steps 5 and 6—Bracket Placement on Solid Wall or Ceiling

7. Insert the Cat 5 cable into the connector.

8. Install the Kensington lock, if you plan to use one.

a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a person

pulling on the cable.

b. Insert the key into the Kensington lock.

c. Insert the Kensington lock into the security slot on the AP.

d. Rotate the key right or left to secure the lock to the AP.

e. Pull on the lock to verify that it is secured to the AP.

f. Remove the key.

9. As shown in Figure 23, place the AP on the bracket, making sure to remove any slack that occurs in the

cable between the bracket and the AP.

Informational Note: Do not insert screws in the four holes on the edges of the bracket. The AP fits into

these holes. They are not screw holes

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 25