Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 16)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Figure 7: Step 12—Locking the Bracket

13. To ensure that the AP is fully locked onto the bracket, gently pull down on the AP and attempt to rotate it

from side to side.

14. If the AP comes off the bracket, relock the device onto the bracket as described in step 12.

15. If the AP requires an external antenna, install and connect the antenna.

Suspended Ceiling Installation—Drop Ceiling Tiles

1. Select an installation location that is centered over a T-bar in the ceiling.

2. Cut a hole as follows in the ceiling tile for the Cat 5 cable:

a. Place the mounting template over the area where you plan to install the AP.

b. Use the box cutter to cut along the line marking the opening for the port connectors.

c. Remove the mounting template and the material you cut from the ceiling panel.

3. Install the T-bar clamp that fits the T-bar:

a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.

b. Slide the two halves of the clamp toward each other until the tabs are inserted completely into the

holes and the clamp fits snugly on the T-bar.

Lock

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 16