Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 11)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Installing an Indoor WLA522

Suspended Ceiling Installation — Flush Ceiling Tiles for the WLA522

1. Select an installation location centered over a T-bar in the ceiling.

2. Cut a hole as follows in the ceiling tile for the Cat 5 cable:

a. Place the mounting template over the area where you plan to install the AP.

b. Use the box cutter to cut along the line marking the opening for the port connectors.

c. Remove the mounting template and the material you cut from the ceiling panel.

3. Determine whether to install a T-bar clamp onto the ceiling T-bar:

a. If the T-bar width is 14.2 millimeter (9/16 inches), you need to install the 14.2-millimeter (9/16 inches)

T-bar clamp. Go to step 4.

b. If the T-bar width is 23.9 millimeter (15/16 inches), the universal mounting bracket fits directly onto the

T-bar. Go to step 5.

4. Install the 14.2-millimeter (9/16-inch) T-bar clamp onto the ceiling T-bar as shown in Figure 1.

a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.

b. Slide the two halves of the clamp toward each other until the tabs are inserted completely into the

holes and the clamp fits snugly on the T-bar.

Figure 1: Step 4—Installing a T-bar Clamp

5. Unlock the universal mounting bracket from the AP by inserting the lock/unlock tool into the Unlock hole

on the AP as shown in Figure 2 below.

Caution: Use a small-pointed instrument or a paperclip to unlock the AP. Do not use a screwdriver

because it may cause damage to the AP lock mechanism or electronic components. Do not use excessive

force when inserting a tool into the Unlock or Lock hole.

T-bar

T-bar clamp halves

Slide together

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 11