Juniper WLA522 Guida di Installazione Scaricare il pdf (Pagina 32)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Installing an Indoor WLA522E Access Point

The WLA522E installation steps for ceiling or wall mount are the same as the WLA522 except that you must

install and orient the four antennas on the AP before supplying power to the unit. The WLA522E has no internal

antennas and requires antennas for all types of operation. Once the AP is installed on either the wall or ceiling

with antennas attached you can switch between Radio 1 and 2 using the CLI command:

set ap # radio x mode disable

WLA522E Installation Antenna Orientation

Adjust the WLA522E antennas as shown below for optimal polarization.

Figure 32: Wall Mount

Warning: Always install the four WLA522E antennas before supplying power to the AP. Failure to do

so can cause damage to the unit.

Warning: The tested/certified antennas are equipped with Reverse-SMA or N-type jacks.

Warning: This device and its antenna(s) must not be co-located or operated in conjunction with any

other antenna or transmitter.

Warning: The external connectors on the WLA522E are labeled 1, 2, 3, 6 on the housing. Each

connector is a RP-SMA connector. Make sure you attach the antenna to the correct connector.

Warning: For products available in the USA/Canada market, only channel 1~11 can be operated.

Selection of other channels is not possible.

Warning: This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in

indoor environment only.

Warning: Always turn the paddle antenna clockwise while adjusting the antenna orientation in order to

prevent loosening of the connector.

Radio port 6

11A

Radio port 1

11B/G

Radio port 2

11B/G

Radio port 3

11A

1 2 ... 27 28 29 30 31 32 33 34 35

Nessun commento

Juniper WLA522 Guida di Installazione Pagina 32