Juniper SRX100 Manuale Scaricare il pdf (Pagina 4)

APPLICATION NOTE - Quickstart Guide for Branch SRX Series Services Gateways

Figure 1: Corporate and branch-office network infrastructure

Configuration

SRX Series Services Gateways can be configured from the command-line interface (CLI) or through the Juniper

Networks J-Web Software GUI. To use J-Web, connect a management PC to interface ge-0/0/0. The IP address of the

PC can be statically configured or assigned by the factory default DHCP server enabled on ge-0/0/0.

For this example, an SRX210 will be configured using the CLI and the management PC will be assigned a static IP

address of 192.168.1.10/24 with a default gateway of 192.168.1.1.

To access an SRX Series device with the JUNOS CLI:

Connect one end of the console cable to the serial port adapter, plug the adapter into a serial port on the PC or •

laptop, and plug the other end of the cable into the console port on the SRX Series device.

Start the terminal emulation program on the PC or laptop, select the COM port, and configure the following port •

settings: 9600 (bits per second), 8 (data bits), none (parity), 1 (stop bits), and none (flow control)

Press the POWER button on the router, and verify that the POWER LED turns green.•

not need to enter a password.)

Enter the UNIX shell after you are authenticated through the CLI:•

Amnesiac (ttyu0)

Password:

JUNOS 9.4B3 built 2008-12-19 00:28:15 UTC

root@%

Type “cli” at the % prompt to start the CLI and press Enter. The prompt changes to an angle bracket (>) when you •

enter CLI operational mode.

root@% cli

root>

Type “configure” at the (>) prompt and press Enter. The prompt changes from > to # when you enter •

configuration mode.

ge-0/0/0

192.168.1.0/24

fe-0/0/7

1.1.1.1/30

UNTRUST ZONE

TRUST ZONE

INTERNET

Untrust Zone

Trust Zone

1 2 3 4 5 6 7 8 9 10 11

Nessun commento

Juniper SRX100 Manuale Pagina 4